If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to see similar items on eBay, and to buy.
IMPORTANT – The decoder does not support sound under DC (analogue) operation. Sounds can only be played under DCC (digital) operation. This applies to all sounds, both running and spot sounds. The locomotive’s motor may be controlled under DC operation.
Function list
F0 Headlight/rearlight (if fitted to locomotive)
F1 Engine start/stop
F2 Horn high-low
F3 Horn low-high
F4 Brake squeal
F5 NOTCH up
F6 NOTCH down
F7 Return to IDLE
F8 Thrash
F9 Cold start override
F10 Compressor
F11 Door slam
F12 Fan
F13 Horn high
F14 Horn low
F15 Primer
F16 Slow flange squeal
F17 Spirax valve
F18 Horn short low
F19 Horn short high
F20 Wagons buffering
F21 Wagons clanging
F22 Alternative door slam
F23 Guard’s whistle
F24 locomotive buffering
F25 Aux (if used in locomotive)
Hornby TTS decoder installation guide Installation guide
– Supports short and long decoder addresses
– Adjustable acceleration and deceleration
– Back EMF load compensation
– Up to 19 controllable spot sounds dependent on model including whistles or horns etc
– Two sound channels allowing for simultaneous play of full locomotive engine sounds, & individual spot sounds e.g. horns, whistles, brakes, wagons coupling etc. NOTE: Only one spot sound can be played at the same time
– It is possible to alter the volume of each sound through an individual dedicated CV. Range 0-8
– Decoder is equipped to support directional front and rear lighting operation via F0 on the controller, providing that the product is fitted with lights
– The decoder is equipped with 1 aux function output controlled by F18 or F25 dependent on locomotive type (diesel or steam)
– Motor current – maximum continuous 500mA
– Motor current – peak 1amp (no function load)
– Function output current maximum100mA (unprotected)
– Decoder current maximum continuous – 800mA (shared motor and functions)
– Number of sound channels – 2
– Termination – 8 pin plug NEM652. NMRA
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to buy, and to see similar items on eBay
Category: Collectables:Model Railways and Trains:Power and Control:Decoders
Location: Norwood, Otley